Category: Warmup Project

• Inputs: 1. Pin touch; 2. Shake.
• Outputs: 1. Sound; 2. Lights.
• The right 4 buttons play 7 keys (from C to B) in different permutations (tone D, F, A are played by buttons working in pairs).
• The left 2 buttons are used to increase/decrease the 7 keys from middle to high/low.
• Lights on the micro-controller would be set to colors corresponding with low, middle or high tones.
•  If it is shaken, a piece of music would be played, and user could pretend the music is played by him or her.

input: capacitive touch, accelerometer

output: digital instruments, low-pass filter sweep

Kermit has lights activated via the Circuit Playground’s buttons (a short press turns the lights on, a long press turns them off), and plays The Rainbow Connection when held upright (activated via the Circuit Playground’s tilt sensor)

 

The lights and sound also activate when the Cube is inverted or the light sensor is covered

 

Wanna have a great noon break? The noon nap pillow will help you embrace the lovely afternoon. Sleep well, think well.

 

Code

Simulation

 

 

 

 

 

This Wisconsin “W” flashes lights and plays an excerpt of our fight song on a shake and flashes lights and plays the beginning of “Jump Around” on a snap, both on a continuous loop until button A is held down.

Pillow that wakes you up with your favorite ring tones.